How would you diagnose the fault of a driveshaft and universal joint?

1 Answer:
  • Ujang Jas
    So if you notice any of the signs below, you may want to bring in your car for a check-up.
    1. Vibrations. An early sign of driveshaft problems is intense vibrations that come from underneath the vehicle. ...
    2. Squeaking Sounds. ...
    3. Clunking Sounds. ...
    4. Other Strange Noises. ...
    5. Movement in the U-Joint. ...
    6. Shuddering While Accelerating.
    14 sept 2020
  • How do I know if my carrier bearing is going out?

    Spinning or Grinding Noise Under the Vehicle

    If you hear a spinning or grinding noise underneath the cabin of the vehicle, it could be a bad carrier bearing if the internal bearings are worn or if the carrier bearing or u-joints are binding and resisting as they turn.
    5 nov 2020
  • What is CV joint boot made of?

    These boots are made of strong rubber that is able withstand the amount of bending the joint does. The boots keep the joint's lubricating grease inside and clean. The boot also protects the joint from wet roads and other debris.
  • Do axle nuts need washers?

    Expert Reply: Yes, there should be a washer of some type between the spindle nut and the bearing on your trailer. The washer protects the back side of the bearing from the edges and points on the back side of the spindle nut.
  • Which U-joints are needed?

    For most cars, 1310-series U-joints are typical choice, but for performance applications, the rugged 1350-series joints are the better choice. The larger the series number, the larger the trunnion. Trunnions are the protruding shafts that the caps ride over. Larger trunnions equate to more torsional strength.16 mar 2017
  • How much does a drive shaft replacement cost?

    Usually, the Drive Shaft Repair costs will differ based on what caused the issue and how fast it can be repaired. If you just have to replace it, that would be anywhere from $500 to $1000. However, you can also expect the cost of the parts to be around half that number and the labor costs around $200.